OB-SX Power Mod

Provide power from your OB-SX to supply your magicBox

The magicBox needs DC 5V 130mA. This is a very low power consumption and there is no reason why not to supply the magicBox with power from the OB-SX. It's a simple modification, but it's important to mention, that this modification should be done by qualified technicians only. Follow the steps below for this upgrade. The magicBox don't need any modification, it's already prepared to work with the OB-SX power mod.


Die MIDIcontrol magicBox benötigt DC 5V 130mA. Dies ist ein sehr geringer Stromverbrauch und es gibt keinen Grund, die magicBox nicht mit Strom aus dem OB-SX zu versorgen. Es ist eine einfache Änderung, aber es ist wichtig zu erwähnen, dass diese Änderung nur von qualifizierten Technikern durchgeführt werden sollte. Führen Sie die folgenden Schritte für dieses Upgrade aus. Die magicBox muss nicht modifiziert werden, sie ist bereits für die Arbeit mit der OB-SX Power Mod. vorbereitet.


BLUE OB-SX POWER MOD

To supply the magicBox with power from your OBSX, please follow the instructions below.

figure1 Click Pic

Figure 1

Cut trace below U67 (as shown in Figure 1 & 2)


figure2 Click Pic

Figure 2

clean the through hole pad below the trace cut


figure3 Click Pic

Figure 3

Solder a 1-ohm resistor between Pin 16 of U67 and the through-hole pad located below the trace cut.


GREY OB-SX POWER MOD

H28 is connected to H23-27 (all to ground),
so there is no trace to cut.

    1. Desolder the H28 female contact from the socket.
    2. Carefully bend Pin 28 out from the plug without breaking it.
    3. Solder a 1-ohm resistor between Pin 28 and the +5V trace.

That's it.

OBSX_GREY Click Pic